beautypg.com

Asus M2NBP-VM CSM User Manual

Page 37

background image

ASUS M2NBP-VM CSM

1-27

3. IDE connectors (40-1 pin PRI_IDE; 40-1 pin SEC_IDE)

The onboard IDE connectors are for Ultra DMA 133/100/66 signal cable(s).

There are three connectors on each Ultra DMA 133/100/66 signal cable:

blue, black, and gray. Connect the blue connector to the motherboard's IDE

connector, then select one of the following modes to configure your device(s).

M2NBP-VM CSM

®

M2NBP-VM CSM IDE connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

PIN 1

SEC_IDE

• Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you

connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as "Cable-Select," make sure all other device

jumpers have the same setting.

Drive jumper setting

Mode of device(s)

Cable connector

Single device

Cable-Select or

Master

-

Black

Two devices

Cable-Select

Master

Slave

Black

Gray

Master

Slave

Master

Slave

Black or gray