AEG Eclipse 10 - Manual (Page 24)

14.3 Answering Machine Settings
14.3.1 Set the Ring Delay
You can select the number of rings before the answering machine answers a call and starts playing the
announcement. You can set the delay from 2 to 7 rings or “TOLL SAVER“.
tFrom the home screen, press
.
tPress again to select “ANS. SYSTEM“.
tPress to “ANS. SETTING” and then press .
tPress to select “RING DELAY”.
tPress to select “2 RINGS“ – “7 RINGS“ or “TOLL SAVER” and then press to confirm.
>A confirmation tone is played.
tPress to return to standby mode.
Note: If you select “TOLL SAVER” the answering machine will answer an incoming call on the fifth ring if
you have no new messages and on the third ring if you do.
When you call your answering machine to check messages, if it does not answer on the third ring, then you
can hang up immediately, knowing that you have no new messages. This feature can save you the cost of
a long-distance call when you check your messages remotely.
14.3.2 Activate/Deactivate Remote Access
tFrom the home screen, press .
tPress again to select “ANS. SYSTEM“.
tPress to “ANS. SETTING” and then press to select.
tPress to “REMOTE ACC.“ and then press to select.
tPress to select “ACTIVATE“ or “DEACTIVATE“ and then press to confirm.
>A confirmation tone is played.
tPress to return to standby mode.
Note: Once the remote control access is activated, you can check the messages on your answering
machine when you are away from home, by calling from another phone.
The Master PIN is used for accessing the answering machine remotely. If your answering machine is off,
you must change your Master PIN from its default 0000 before you can use the remote access feature to
turn on your answering machine.
14.3.3 Change the Voice Language
You may be able to select a different language for the answering machine’s pre- recorded announcements.
tFrom the home screen, press .
tPress again to select “ANS. SYSTEM“.
tPress to “ANS. SETTING” and then press to select.
tPress to “LANGUAGE” and then press to select.
tPress to select your preferred language (if available) and then press to confirm.
>A confirmation tone is played.
tPress to return to standby mode.