How to access the web/snmp management card, Overview, Web interface – APC AP9606 User Manual
Page 17: Telnet, Snmp, Apc management card wizard, Overview 13, Web interface 13, Telnet 13, Snmp 13

13
How to Access the Web/SNMP Management Card
Overview
Once the Management Card is running on your network, you can
use several different interfaces to access the Management Card.
Note: For more information about how to use the interfaces
identified here, see the Web/SNMP Management Card
User’s Guide (.\doc\usrguide.pdf) and the Management
Card Addendum (.\doc\addendum.pdf).
Web interface
You can use Internet Explorer (3.01 or later) or Netscape
®
Navigator (3.0 or later) to configure Management Card options,
or to view the Event log.
1. Address the Management Card by its IP address or DNS
name (if configured).
2. Enter the User Name and Password (apc by default).
Telnet
You can use Telnet to view the event log or to configure
Management Card options.
1. At a command prompt, type
telnet address
and
press
E
NTER
, where
address
is the Management Card’s
IP address or DNS name (if configured).
2. Enter the User Name and Password (apc by default).
SNMP
After you add the PowerNet MIB to a standard SNMP MIB
browser, you can use that browser for SNMP access to a
Management Card. The default read community name is public;
the default read/write community name is private.
FTP
You can use FTP (enabled by default) to download new
firmware or to access a copy of the event log.
1. At a command prompt, type
ftp address
and press
E
NTER
, where
address
is the Management
Card’s IP address.
2. Enter the User Name and Password (apc by default).
APC
Management
Card Wizard
You can use the APC Management Card Wizard to download
new firmware and to reconfigure multiple Management Cards
over the network.