Xerox WorkCentre M118-M118i-15205 - Manual (Page 77)

Xerox CopyCentre/WorkCentre 118 System Administration Guide 77
8 Parallel Port
This chapter explains how to set up the machine in a parallel port environment. The
following information is provided.
Information Checklist – page 77
Parallel Port Environment – page 78
Parallel Port Installation – page 78
Installation Procedure – page 78
Parallel Port Communication Setup – page 78
Workstation Setup – page 79
Test Print – page 79
Information Checklist
Before starting the parallel port installation procedures, make sure that the following
items are available or have been performed.
NOTE: The installation procedures will install the machine on the parallel port of the
host workstation. The procedures are not intended to connect the host workstation to
other workstations.
If problems are encountered during the installation of the machine, refer to Problem
Solving chapter for assistance.
CAUTION: Do not connect the parallel port cable to the machine until instructed
to do so.
Item By
IEEE1284 Parallel Port Cable Customer
Test the machine to make sure that it is installed fully and functioning
correctly. Customer
Print driver for the machine Customer