Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-15619 - Manual (Page 7)

Installation worksheets
The Getting Ready for the DocuSP Installation guide has been
developed for you to use in the gathering of technical data that
will be required by the Xerox personnel during installation of
your customer’s Document Services Platform hardware and
software. It is used in conjunction with the appropriate printer
installation planning guide.
Using the installation worksheets
The Xerox printer with DocuSP software provides a wide range
of network printing services on industry-standard networks, and
consists of the following:
• The DocuSP controller is a UNIX-based computer
workstation with a Xerox interface PWB and DocuSP
software installed.
• A supported Xerox printer.
Getting Ready for the DocuSP Installation contains the
worksheets that must be completed to support the installation of
the Xerox DocuSP software on the controller.
When these worksheets are completed they will contain a
record of the state of the system at the time of install. Most
likely, this setup and configuration state will change, so
encourage your customer to keep these worksheets with the
service record of the printer for future reference.
Your customer should not complete the worksheets if they are
not sure of the required information. Always encourage them to
contact the next level of technical support within their
organization for assistance.
NOTE: Worksheet 5, the Novell NetWare gateway installation
worksheet, refers to on-site setup requirements that your
customer’s network administrator should already have
implemented prior to the DocuSP install. The values for the
data elements entered during that setup activity should be
recorded on this worksheet.
XEROX DOCUMENT SERVICES PLATFORM SERIES 1
GETTING READY FOR THE DOCUSP INSTALLATION