Konica Minolta bizhub 750 - Manual (Page 26)

Administrator Operations 2
750/600 2-7
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
cessful. In this case, click [OK] and enter the correct Administrator
Password in the “Administrator Password” box.
% If the Enhanced Security mode is set to [ON], entry of a wrong pass-
word is counted as unauthorized access. If a wrong Administrator
Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine or more, a
message appears saying that the machine accepts no more Admin-
istrator Passwords because of unauthorized access for any subse-
quent entry of the Administrator Password. The machine is then set
into an access lock state. To cancel the access lock state, turn off,
and then turn on, the main power switch of the machine. When the
main power switch is turned off, then on again, wait at least 10 sec-
onds to turn it on after turning it off. If there is no wait period be-
tween turning the main power switch off, then on again, the
machine may not function properly.
Here is the sequence, through which the main power switch and
sub power switch are turned on and off:
Turn off the sub power switch
→ Turn off the main power switch →
Turn on the main power switch → Turn on the sub power switch
? What if you fail to log on to the Administrator Setting mode?
% If you have already logged on to the Administrator Setting mode
from the control panel or using PageScope Web Connection, the
machine displays a message that tells that another administrator
has previously logged on and rejects any attempt to log on to the
Administrator Setting mode using the PageScope Web Connec-
tion. Click [OK] and wait for some while before attempting to access
the Administrator Setting mode once again.
% If [Export to the device] operation is being executed using the Pag-
eScope Data Administrator, the machine displays a message that
tells you cannot log on to the mode because of the remote opera-
tion being performed and rejects any attempts to the Administrator
Setting mode via the PageScope Web Connection. Click [OK] and
wait for some while before attempting to access the Administrator
Setting mode once again.
? Is it possible to gain access to the Administrator Setting mode while
a job is being executed?
% If an attempt is made to log on to the Administrator Setting mode
while a job is being executed, the machine gives a message that
tells that it is now impossible to log on to the Administrator Setting
mode. Click [OK] and try logging on to the Administrator Setting
mode after the execution of the job is completed.
7
Click the [Logout].
600_security_E.book 7 ページ ２００６年１２月２７日 水曜日 午前７時５０分