Konica Minolta pagepro 5650 - Manual (Page 195)

Status, Error, and Service Messages 185
Error Messages (Operator Call: )
This message... means... do this...
CHECK LEVER
FACE UP TRAY
IS SELECTED
The face up lever is
raised when duplex
printing or sub tray
output is specified. Pull the face up lever
down.
COVER OPEN
DUPLEX COVER
The duplex cover is
open. Close the duplex cover.
COVER OPEN
FINISHER COVER
The offset tray cover
is open. Close the offset tray
cover.
COVER OPEN
REAR COVER
The printer's rear
cover is open. Close the rear cover.
COVER OPEN
TOP COVER
The printer's top
cover is open. Close the top cover.
HOLD JOB ERROR
UNABLE TO
STORE JOB
The specified print job
saved on the hard
disk is sent while the
hard disk is not
installed. Print jobs can be saved
only if a hard disk is
installed. If desired,
install a hard disk.
HOLD JOB ERROR
“OPTIONAL”
PRESS CANCEL
When printing a
stored job, the printer
configuration was
changed since the job
was stored. Change the printer con-
figuration to that when
the job was stored.
INCORRECT TRAY
The installed option
tray is an unap-
proved type. (pagepro
5650EN only) Turn off the power of the
printer, and then remove
the tray.
MEMORY FULL
PRESS CANCEL
The printer has
received more data
than can be pro-
cessed with its inter-
nal memory. Press the Cancel key to
cancel the print job.
Decrease the amount of
data to be printed (for
example, by decreasing
the resolution), and then
try printing again.
If that doesn’t solve the
problem, install an
optional memory mod-
ule.