Konica Minolta magicolor 8650 - Manual (Page 18)

8650 2-3
Administrator Operations 2
1
Press the [Menu/Select] key.
2
Press the [,] key to select [Admin. Settings].
? Is it possible to gain access to the Admin. Settings while a job is being executed?
% The machine does not accept access to the Admin. Settings while a job is being executed. Wait until
the execution of the job is completed before attempting to access the Admin. Settings again.
3
Press the [Menu/Select] or [)] key.
4
Press the [+] and/or [,] key to enter the 8-digit Administrator Password.
– Press the [*] key to delete the last character entered.
5
Press the [Menu/Select] key.
? What happens if a wrong Administrator Password is entered?
% If a wrong Administrator Password is entered, a message appears saying that there is a mismatch
in the Administrator Passwords and entry of the Administrator Password will be prohibited for five
sec. Wait for some while before entering the correct Administrator Password.
% If the EnhancedSecurity is set to [ON], entry of a wrong password is counted as unauthorized ac-
cess. If a wrong Administrator Password is entered a predetermined number of times (once to three
times) set by the Administrator of the machine or more, a message appears saying that the machine
accepts no more Administrator Passwords because of unauthorized access for any subsequent en-
try of the Administrator Password. The machine is then set into an access lock state. To cancel the
access lock state, settings must be made by the Service Engineer; or, turn off, and then turn on, the
main power switch of the machine. If the main power switch is turned off and on, the access lock
state is canceled after the lapse of time set for [Release Time]. When the main power switch is
turned off, then on again, wait at least 10 seconds to turn it on after turning it off. If there is no wait
period between turning the main power switch off, then on again, the machine may not function
properly.
6
Press the [Cancel] key to log off from the Admin. Settings.