Konica Minolta bizhub PRESS C1100 - Manual (Page 21)

bizhub PRESS C1100/C1085 2-13
2.3 Administrator Security Functions
2
6
Press [01 HDD Lock Password].
The HDD Lock Password Screen is displayed.
7
Press [Current Password] to enter the password currently used, then press [OK].
Default password is the main body serial number consisting of 13 alphanumeric characters.
% The main body serial number as 13 alphanumeric characters is displayed on the upper left corner
of the Utility Menu Screen or on the upper right corner of the output audit log. For details, refer to
the next section "Outputting Audit Log."
8
If the authentication has succeeded, press [New Password] to enter a new password.
NOTICE
Do not use your name, birthday, employee number, etc. for a password that others can easily figure out.
% You may enter 8 to 32 alphanumeric characters for the HDD lock password.
% If a wrong password or fewer than 8 alphanumeric characters are entered and [OK] is pressed, the
warning message [Password is incorrect / Please wait for a while / Please wait for a while] is dis-
played, and no key will work for five seconds. Enter the correct password after five seconds.
% The information about failed authentication is saved in the audit log.
% The information about changing password is saved in the audit log.
% The current password cannot be used again as a new password.
% Press [OK] when completed.
9
Press [Input Confirmation] to enter the same password as above.
% Press [OK] when completed.
10
Press [OK] on the HDD Lock Password Screen.