Konica Minolta KIP 3100 - Manual (Page 19)

Chapter 1 Before Use 1-14
Pre-printed
Extremely slippery
Extremely sticky
Extremely thin and soft
OHP Film
1. 7. 2 Proper Care of Printing Paper
Follow these steps in taking care of your printing paper.
1. Do not expose the paper to the direct sunlight.
2. Keep the paper away from high humidity. (It must be less than 70%)
3. Put the paper on a flat place
4. Place unused paper back into its original polyethylene bag to avoid the humidity.
CAUTION
Do not use paper with staples, and do not use conductive paper such as aluminium foil and
carbon paper.
The use of these materials may cause a fire.
NOTE
(1) Print image may become light if printed on a rough surface of the paper.
(2) Print image may become defective if the print paper has an excessive curl.
(3) It will become a cause for paper mis-feed, defective print image or crease of paper if you
use a paper that does not satisfy the specification.
(4) Do not use a paper of which surface is very special, such as thermal paper, art paper,
aluminium foil, carbon paper and conductive paper.
(5) Tracing paper exposed to air over a long period tends to cause defective printing.
Removing one round from the beginning of the roll surface of the tracing paper is
recommended.
Refer to [2.3 Replacement of Roll Paper] on page 2-5.