Konica Minolta bizhub C364 - Manual (Page 33)

bizhub C554/C454/C364/C284/C224 2-21
2.7 Protecting Data in the HDD 2
2.7 Protecting Data in the HDD
When access to the machine by the administrator of the machine through the Administrator Settings is au-
thenticated, the machine enables the operation for setting and changing the Encryption Key.
By setting the Encryption Key, the data saved in the HDD is encrypted, thereby protecting the data in the
HDD. The Encryption Key entered is displayed as "*."
Reference
- When an Encryption Key (encryption word) is set using HDD Encryption Setting, an Encryption Key with
a key length of 128 bits is generated. The generated encryption key is used to encrypt or decrypt data
through AES encryption algorithm.
2.7.1 Setting the Encryption Key (encryption word)
0 For the procedure to call the Security Settings screen on the display, see steps 1 and 2 of page 2-12.
0 Do not leave the machine with the setting screen of Administrator Settings left shown on the display. If
it is absolutely necessary to leave the machine, be sure first to log off from the Administrator Settings.
0 To prevent data from leaking as a result of reinstallation of the HDD on another machine, a unique value
that varies from one machine to another must be set for the encryption key.
0 Do not set any number that can easily be guessed from birthdays, employee identification numbers,
and the like for the Encryption Key. Try to change the Encryption Key at regular intervals.
0 Make sure that nobody but the administrator of the machine comes to know the Encryption Key.
0 If only the Encryption Key is to be set while the machine is being used without setting the Encryption
Key, the Service Engineer must perform some setting procedures in advance. For details, contact your
Service Representative.
0 To edit/release the Encryption Key, see page 2-25. Do not release the Encryption Key when the En-
hanced Security Mode is set to [ON]. Releasing the Encryption Key will cancel the Enhanced Security
Mode.
0 Executing HDD Format erases data in the HDD. It is recommended that important data should be saved
in a backup medium in advance. Execution of HDD Format will also reset the setting values of different
functions to the default values. Set the Enhanced Security Mode to [ON] again. For the functions whose
settings are reset to the default values, see page 2-7.
1
Call the Security Settings screen on the display from the control panel.
2
Touch [HDD Settings].