Konica Minolta bizhub 652 - Manual (Page 17)

Using AU-201H Authentication Unit 3
AU-201H 17
Registering users
Detail:
In order to register users with Data Administrator, this device must be connected
to the USB port of the computer, and the computer and multifunctional product
must be connected over a network.
1
If this device is connected to the multifunctional product, turn off the
multifunctional product with the main power switch, and then disconnect this
device.
– If this device is connected to the computer, continue with step 4.
Note:
• When the multifunctional product is turned off, then on again with the main
power switch, wait at least 10 seconds to turn the machine on after turning it off.
The machine may not operate correctly if it is turned on immediately after being
turned off.
• Hold the plug when plugging and unplugging the USB cable, otherwise the cable
may be damaged.
2
Turn on the multifunctional product with the main power switch.
3
Connect this device to the USB port of the computer installed with Data
Administrator.
Multifunctional product
Network
Computer
USB
This device