Konica Minolta magicolor 5650 - Manual (Page 373)

Configuring the Printer 353
Access Refuse
Address If Enable is selected, the range of IP addresses refused
access to the printer can be specified.
A maximum of five ranges of refused IP addresses can be
specified.
If Disable is selected, the refused access setting is
disabled.
Choices: Enable, Disable
Default: Disable
Configuration Menu Equivalent:
INTERFACE MENU - ETHERNET - TCP/
IP - IP ADDRESS FILTER - ACCESS
REFUSE
Range of IP
address refused
access* Specify the range of IP addresses refused access to the
printer. Type the IP address at the beginning of the range
into the box on the left, and the IP address at the end of
the range into the box on the right.
Range: 0-255 for each xxx triplet
Default: 0.0.0.0
"
To specify a single IP address, type the same IP
address into both the box for the starting IP address
and for the ending IP address, or type “0.0.0.0” into
the box for either the starting IP address or the
ending IP address.
"
If the starting IP address is larger than the ending
IP address, the setting is not applied.
Apply button Applies the configuration settings in this page.
Clear button Resets all configuration settings to previous values.
* Always enter these addresses without leading zeros. For example,
131.011.010.001 should be entered as 131.11.10.1.
Item Description