Asus P5B-E Plus - Manual (Page 81)

ASUS P5B-E Plus -1
4.3.7 AHCI Configuration
This menu is the section for AHCI configuration. It appears only when you set the
item Configure SATA as from the sub-menu of IDE Configuration to [AHCI].
ACHI Port0~5 [XXXX]
Displays the status of auto-detection of IDE devices.
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2006, American Megatrends, Inc.
BIOS SETUP UTILITY
Main
AHCI Settings
AHCI Port0 [Not Detected]
AHCI Port1 [Not Detected]
AHCI Port2 [Not Detected]
AHCI Port3 [Not Detected]
AHCI Port4 [Not Detected]
AHCI Port5 [Not Detected]
If you want the Serial ATA hard disk drives to use the Advanced Host Controller
Interface (AHCI), set this item to [AHCI].
Hard Disk Write Protect [Disabled]
Disables or enables device write protection. This will be effective only if device is
accessed throuh BIOS. Confiuration option: [Disabled] [Enabled]
IDE Detect Time Out (Sec) [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
While entering setup,
BIOS auto detects
the presence of IDE
devices. This displays
the status of auto
detection of IDE
devices.
AHCI Port0
Device :Not Detected
SATA Port0 [Auto]
Select the type of
device connected
to the system
SATA Port0 [Auto]
Allows you to select the type of device connected to the system.
Configuration options: [Auto] [Not Installed]