Asus P5B-E Plus - Manual (Page 143)

ASUS P5B-E Plus 5-37
5.4.4 JMicron ® RAID Configuration
The JMicron ® Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk
3. Microsoft
® Windows ® OS installation disk (Windows 2000/XP)
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the external Serial ATA hard disk drives (HDDs) on your system.
2. Set the
JMicron Controller Mode item in the BIOS to [RAID]. See section
“4.4.6 Onboard Devices Configuration” for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
® OS installation. See section
“5.5 Creating a RAID driver disk” for details.
5. Install the JMB363 driver after the Windows ® OS had been installed.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2006, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
Configure Win627EHF Super IO Chipset
HD Audio Controller [Enabled]
Front Panel Support Type [HD Audio]
Onboard 1394 Controller [Enabled]
Onboard PCIE GbE LAN [Enabled]
LAN Option ROM [Disabled]
JMicron SATA/PATA Controller [Enabled]
JMicron SATA Controller Mode [SATA]
Serial Port1 Address [3F8/IRQ4]
Enable or Disable
High Definition Audio
Controller
Always install the JMB363 driver before creating RAID sets.