Asus P5B-E Plus - Manual (Page 52)

- Chapter : Hardware information
4. JMicron ® JMB363 Serial ATA RAID connector (7-pin SATA_RAID)
This connector is for a Serial ATA signal cable. This connector supports
a Serial ATA hard disk drive that you can configure for RAID through the
onboard Serial ATA RAID controller.
The JMicron ® JMB363 controller item in the BIOS is set to [IDE] by default,
allowing you to use the connectors to build a RAID set. See section “4.4.6
Onboard Device Configuration” for details.
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the JMicron ® JMB363 RAID utility and SATA
BIOS setup during POST.
P5B-E PLUS
®
P5B-E PLUS SATA_RAID connector
SATA_RAID
G
ND
RS
AT
A_
TX
P1
RS
AT
A_
TX
N1
G
ND
RS
AT
A_
RX
P1
RS
AT
A_
RX
N1
G
ND