AMD GA-K8N ULTRA-9 - Manual (Page 45)

BIOS Setup - 45 -
English
HT-Link voltage control
Normal Supply HT-Link voltage as HT-Link required. (Default value)
+0.1V Increase HT-Link voltage +0.1V.
+0.2V Increase HT-Link voltage +0.2V.
+0.3V Increase HT-Link voltage +0.3V.
DDR voltage control
Please note that by overclocking your system through the increase of the DDR voltage, damage
to the memory may occur.
Normal Supply DDR voltage as DDR required. (Default value)
+0.1V Increase DDR voltage +0.1V.
+0.2V Increase DDR voltage +0.2V.
2-8 Load Optimized Defaults
Selecting this field loads the factory defaults for BIOS and Chipset Features which the system automatically
detects.
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
` Standard CMOS Features
` Advanced BIOS Features
` Integrated Peripherals
` Power Management Setup
` PnP/PCI Configurations
` PC Health Status
ESC: Quit KLJI: Select Item
F8: Dual BIOS/Q-Flash F10: Save & Exit Setup
Load Optimized Defaults
` MB Intelligent Tweaker(M.I.T.)
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
Load Optimized Defaults (Y/N)? N
2-9 Set Supervisor/User Password
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
` Standard CMOS Features
` Advanced BIOS Features
` Integrated Peripherals
` Power Management Setup
` PnP/PCI Configurations
` PC Health Status
ESC: Quit KLJI: Select Item
F8: Dual BIOS/Q-Flash F10: Save & Exit Setup
Change/Set/Disable Password
` MB Intelligent Tweaker(M.I.T.)
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
Enter Password:
When you select this function, the following message will appear at the center of the screen to assist
you in creating a password.
Type the password, up to eight characters, and press . You will be asked to confirm the
password. Type the password again and press . You may also press to abort the
selection and not enter a password.