Lenovo IdeaCentre Q200 - Manual (Page 26)

23
Hardware Replacement Guide
Important
To avoid damaging the microprocessor contacts, do not tilt the
microprocessor when installing it into the socket.
18. Lower the microprocessor straight down into the system board socket of the
new system board.
19. To secure the microprocessor in the socket, close the microprocessor retainer
and lock it into position with the small handle.
20. Install the retention module for the heat sink and fan assembly on the system
board.
21. Install the heat sink and fan assembly on the system board.
22. Connect the heat sink and fan assembly cable to the new system board. See
the system board illustration for your machine type at “Identifying parts on the
system board”.
23. Install the new system board into the chassis and align the screw holes with
those in the chassis. Insert and tighten the screws that secure the system
board.
24. Connect all cables to the system board. See the system board illustration for
your machine type at “Identifying parts on the system board” .
25. Refer to the “Completing the installation”.
Replacing the microprocessor
Attention
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM
, go to the Support Web site at http://www.lenovo.com/support.
31032756_HaWaii-HRG_EN.indd 23 2008.1.8 3:31:37 PM