Alamo Switchblade Sickle Bar 5 - Manual (Page 85)

OPERATION
SB5/6 03/09 Operation Section 3-11
© 2009 Alamo Group Inc.
OPERA
T
ION
SICKLE BAR ASSEMBLY
•
Inspect condition of Serrated Knifes.
• Inspect condition of Sickle Bar knife guards.
• Ensure all bolts and screws are in position and
are properly torqued.
• Ensure all knife clips are in place and fastened
with screws.
• Ensure Sickle Bar is properly mounted to frame
and tractor and hardware is propely installed
and tightened. OPS-SB- 0003
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running.
(SG-20)
HYDRAULIC LINE INSPECTION
•
Check for hydraulic leaks along hoses,
cylinders and fittings. IMPORTANT: DO NOT
use your hands to check for oil leaks. Use a
piece of heavy paper or cardboard to check for
hydraulic oil leaks.
• Inspect the condition of the valve weldment.
• Ensure fitting is properly connected
OPS-SB- 0004
Hydraulic Hoses
Do not operate this Equipment with hydraulic oil or fuel leaking. Oil
and fuel are explosive and their presence could present a hazard. Do
not check for leaks with your hand! High-pressure oil streams from
breaks in the line could penetrate the skin and cause tissue damage
including gangrene. To check for a hose leak, SHUT the unit ENGINE
OFF and remove all hydraulic pressure. Wear oil impenetrable gloves,
safety glasses and use Cardboard to check for evidence of oil leaks. If
you suspect a leak, REMOVE the HOSE and have it tested at a Dealer.
If oil does penetrate the skin, have the injury treated immediately by a
physician knowledgeable and skilled in this procedure.
(SG-15)