Lenovo Secure Managed Client - Manual (Page 28)

Front operator's panel LEDs and switches
The front operator’s panel LED fault and status conditions are defined in Table 4.
Functions of the push-button switches are defined in Table 5.
1 USB port
2 Power active LED
3 Unit fault LED
4 ID LED
5 On/off switch
6 Reset button (recessed)
7 ID LED activation switch
Table 4. Front operator's panel LED states
LED Status
Power active Constant green: good or positive indication
Unit fault Constant amber: fault present
Enclosure ID Blue: only when activated
Table 5. Front operator's panel switch functions
Push-button
switch Definition
On/Off Function of this button is dependent on the enclosure status.
Enclosure connected to power source but not operating.
Press button to activate and commence boot process.
Enclosure operating : Depress button for <4 seconds to turn off
the enclosure.
System reset Resets the enclosure hardware and firmware.
This button is recessed and is activated with a ball-point pen or similar
implement.
Enclosure ID Each press of this button causes the state of the blue ID LED on the Front
Operator's Panel and rear panel to change.
Figure 18. Front operator’s panel components
20 User Guide