Lenovo Secure Managed Client - Manual (Page 21)

Chapter 3. Getting Started
In this chapter, you are shown how to plan and install your Secure Managed Client
(SMC) - Storage Array into an industry standard 48.26-cm (19-inch) rack cabinet.
CAUTION:
When connecting the SMC - Storage Array, use only the power cords supplied or
power cords that match the specification quoted in the Safety and Warranty Guide.
Planning your installation
Before installing the SMC - Storage Array, familiarize yourself with the
configuration requirements listed in the following table.
CAUTION:
Installation procedures should be performed by trained personnel only.
Table 3. Configuration requirements
Module Location
Drive bays All drive bays must be installed with either
a drive carrier module or a dummy drive
carrier module. No bays should be left
empty. A minimum of 1 drive must be
installed.
Power supply One PSU can be installed. A blanking plate
must be installed to cover the empty (top)
slot.
Cooling fans Ten fans, housed in a cooling cage, are
located centrally within the enclosure
between the drive bays and the server
board.
PCI cards Up to six PCI cards can be installed in a
vertical orientation. Currently, only the two
outer card slots are used in the standard
configuration, installed with an Intel ® RAID
Controller SRCSAS144E and an Intel ®
Intelligent AXXRIBBU1 Battery Backup Unit.
When not in use, the four empty PCI slots
must be installed with blanking plates.
Drive bay numbering convention
The drive bay numbering convention is as follows.
© Copyright Lenovo 2005, 2008 13