AOpen D X37PU-EG-E0110A - Manual (Page 6)

15. Power-On and Load BIOS Setup
After you finish the setting of jumpers and connect correct cables. Power on and enter the
BIOS Setup, press during POST (Power On Self Test). Choose "Load Default
Setting" for recommended optimal performance.
Del
17. Installing Onboard Sound Driver
This motherboard comes with an AD 1885 AC97 CODEC, you can find the audio driver
from the Bonus Pack CD disc auto-run menu.
16. Wake On LAN
14. Support 10/100 Mbps LAN onboard
The South Bridge V8233 of VIA Apollo Pro266T chipset includes a fast Ethernet controller on
chip. On the strength of Intel 82550 PHY on board, which is a highly-integrated Platform LAN
Connect device, it provides 10/100M bps Ethernet for office and home use, the Ethernet RJ45
connector is located on the back panel. The green LED indicates the link mode, it lights when
linking to network and blinking when transferring data. The orange LED indicates the transfer
mode, and it lights when data is transferring in 100Mbps mode. To enable or disable this
function, you may simply adjust it through BIOS.
Green/ACT
Orange/Speed
To use Wake On LAN function, you must have a network card with chipset that supports this
feature, and connect a cable from LAN card to motherboard WOL connector. The system
identification information (probably IP address) is stored on network card and because there is
a lot of traffic on the Ethernet, you need to install a network management software, such as
ADM, for the checking of how to wake up the system. Note that, at least 600mA ATX standby
current is required to support the LAN card for this function.
+5VSB
GND
LID