Kodak ESP 3 - Manual (Page 41)

Maintenance
Maintenance
This section provides maintenance information for the Kodak ESP 3 All-in-One printer.
The Kodak ESP 3 All-in-One printer requires little maintenance. However, you should regularly
clean the scanner glass and lid backing to remove dust and fingerprints. Fingerprints and other
debris on the glass or lid backing could slow down performance and affect the accuracy of
scanning.
General Care
Important Always disconnect the power on the Kodak ESP 3 All-in-One printer before cleaning.
Do not use harsh or abrasive cleaners or organic solvents on the printer or any of its
parts.
Warning Do not leave items on the scanner glass. The heat of the scanning lamp may
cause them to stick.
•
To clean, wipe the outside of the printer with a clean, dry cloth.
•
Keep the surrounding area vacuumed and litter-free.
•
Protect the printer from tobacco smoke, dust, sand, and liquid spills.
•
Avoid placing objects on the printer.
•
Keep the printer, accessories, and supplies away from direct sunlight and out of high-
temperature environments.
•
Do not allow chemicals, such as suntan lotion, to come into contact with the painted surface of
the printer.
•
If the printer has been subjected to inclement weather or you suspect water has gotten inside
the printer, turn it off and let it dry out. If this does not resolve the problem, contact customer
support (see Telephone Customer Support).
•
Service agreements are available in some countries. Contact a dealer of Kodak products for
more information.
•
For more recycling and or disposal information, contact your local authorities. In the US, visit
the Electronics Industry Alliance Web site at
www.eiae.org .