Kodak HERO 5.1 - Manual (Page 30)

24 www.kodak.com/go/aiosupport
4
Safety and Warranty Information
Safety Information
KODAK OFFICE HERO 5.1 All-in-One Printer is a Class 1 LED Product.
■ Always follow all warnings and instructions marked on the product.
■ Use only the power source indicated on the product regulatory label.
■ Use only the power cord that comes with the product (or an approved power cord
greater than or equal to H05W-F, 2G, 0.75 mm2). Using another power cord may
cause fire and/or shock. Do not use the included power cord with any other
equipment.
■ If you do not use this product for a long period of time, unplug it from the electrical
outlet.
■ Always turn this product off by using the power button. Wait until the power button
stops flashing before removing the power plug from the outlet.
■ Do not allow the power cord to become damaged or frayed.
■ If you need to use an extension cord with this product, make sure that the ampere
rating of the product does not exceed the ampere rating of the extension cord.
■ Place the product on a flat, stable surface that extends beyond the product’s base in
all directions. This product will not operate properly if tilted or at an angle.
■ When storing or transporting this product, do not tilt or stand it on its side. Never turn
this product upside down (ink can leak out of the product).
■ Avoid placing this product in an environment that is subject to rapid changes in
temperature or humidity, mechanical shocks, vibration, or dust. Do not place near
radiators, heating vents, or in direct sunlight.