Actiontec electronic Actiontec Wireless DSL Gateway GT704WG User Manual
Page 15
10
Actiontec 54 Mbps Wireless DSL Gateway User Manual
11
Chapter 2 Performing a Quick Setup
5b. If
PPP
o
E
was selected in step 5, select the
IP
type (“Dynamic
IP-DHCP
[Default]” or “Single Static
IP
Address”). If Single Static
IP
Address was select-
ed, enter the address in the appropriate text box.
6. Optional - Select the
DNS
type (“Dynamic
DNS
Addresses [Default]” or
“Static
DNS
Addresses”). If Static
DNS
Addresses was selected, enter the pri-
mary and secondary
DNS
addresses in the appropriate text boxes. If unsure
what to enter in this section, contact the
ISP
.
7. Click Apply at the bottom of the screen.
8. Read the instructions on the next screen. The Gateway is successfully
configured.
The Power light flashes rapidly while the Gateway restarts, then glows steadily
green when fully operational. The Internet light will also glow steadily green. The
Gateway is now configured and users can start surfing the Internet.
If an error appears, stating the Web browser was unable to connect to the Internet,
check the configuration settings. Ensure all the information required by the
ISP
is
entered correctly.