Vollrath SO212 - Manual (Page 13)

7
Figure 3-1 Controls
3.1 OPERATOR’S SAFETY PRECAUTIONS
Safe operation is no accident; observe these rules:
A. Know the freezer. Read and understand the
operating instructions.
B. Notice all warning labels on the freezer.
C. Wear proper clothing. Avoid loose fitting garments,
and remove watches, rings or jewelry which
could cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E. Stay alert at all times. Know which switch, button
or control you are about to use and what effect it
is going to have.
F. Disconnect electrical cord for maintenance. Never
attempt to repair or perform maintenance on the
freezer until the main electrical power has been
disconnected.
SECTION 3
INITIAL SETUP AND OPERATION
G. Do not operate under unsafe operating conditions.
Never operate the freezer if unusual or excessive
noise or vibration occurs.
3.2 OPERATING CONTROLS AND
INDICATORS
Before operating the freezer, it is required that the operator
know the function of each operating control. Refer to
Figure 3-1 for the location of the operating controls on the
freezer. For the information regarding flashing indicator
lights, refer to Section 4 - Troubleshooting.
WARNING
The Power OFF-ON switch must be placed in the
OFF position when disassembling for cleaning or
servicing. The freezer must be disconnected from
electrical supply before removing any access panel.
Mix Low
Indicator
CLEAN
Switch
PUSH TO FREEZE
Switch
Blender
Power Switch
Hold/Ready
Switch
Consistency/
Temperature
Adjustment
OFF-ON
Power Switch