Silent Call 1008-4 - Manual (Page 19)

19
Programming
The smoke detector is pre-programmed at the factory.
Switch Settings
The Silent Call system is digitally coded. The code sent by the
transmitter must match the code that your receiver has been set for.
All Silent Call receivers and transmitters leave the factory set for the
default code of 1, 2 and 3=Off and 4 and 5=ON.
Mounting
First, determine the best location for the smoke detector, one
that provides a strong wireless transmission path and proper
smoke detection. A GOOD TRANSMISSION PATH MUST BE
ESTABLISHED FROM THE PROPOSED MOUNTING LOCATION
Test Switch
Green LED
Red LED
Figure 7: Silent Call Model #1008-4
Wireless Smoke Detector