Sheffer HH SERIES - Manual (Page 23)

Rod End Information
Used with S.A.F.E. accessory (see
separate Accessories Brochure) for
fast, close radial alignment.
Female thread, used with male
accessories for shorter overall
cylinder length.
Male thread larger in diameter than
style 2. No shoulder for locking.
Stud not used.
Plain male Rod End with no threads.
Used for pushing, holding, knock-
outs, etc.
High Tensile, rolled thread stud with
two times A length is available on Rods
thru 2" in diameter.
Spanner Wrench Holes are provided
in lieu of Wrench Flats on larger Rod
sizes. See Rod End Dimensions on
opposite page.
IMPORTANT NOTE:
Style 2 Rod End is standard
and will be furnished unless
otherwise specified. Alternate
Rod End styles 1, 3, 4 and 6
are available at no extra
charge. Style 2X and other
special Rod End styles are
available for a nominal extra
charge. A wide selection of
Rod End accessories is shown
in separate Accessories
Brochure.
STANDARD – STYLE 2
Alternate – Style 1
Spanner Wrench Holes
in Lieu of Flats Alternate – Style 3
Optional – Style 2X Alternate – Style 4
Alternate – Style 6
KK THREAD
D
WRENCH
FLATS
D
WRENCH
FLATS
MM
DIA.
A A
A
C
C C
C
C 2xA
VA OR V
VA OR V
VA OR V
VA OR V
VA OR V
VA OR V
VA OR V
MM
DIA.
B
DIA.
NA
DIA.
NA
DIA.
NA
DIA.
NA
DIA
.
AF
DIA.
B
DIA.
20º
1 + 1 / 16
8 - 0
B
DIA. B
DIA.
B
DIA. B
DIA.
B
DIA.
AE
AD
AC
MM
DIA.
MM
DIA.
MM
DIA.
MM
DIA.
MM
DIA
.
KK THREAD
1 / 2 " SPANNER
HOLES
KK THREAD KK THREAD
CC THREAD
Male thread with adequate shoulder for
locking accessory. High tensile, rolled
thread stud used on all Rods thru 2
1 / 2 "
in diameter.
C A
4 WRENCH
FLATS
STANDARD
1 HH-22