Sheffer HH SERIES - Manual (Page 12)

LUG MOUNTINGS
Mountings
US
E
TS
SW
SW
ST
E
K
SW SU
XS
SU
WF
Y
ZB + STROKE
P + STROKE
EE
SS + STROKE
MM
ROD
DIA.
SW
E-.003
2-.008
SB
BOLT
SIZE
US
E
E
TS
SW
SW
ST
SW SU
XS
WF
Y
SU SW
K
MM
ROD
DIA.
ZB + STROKE
P + STROKE
EE
SS + STROKE
SB
BOLT
SIZE
E
E
EB
BOLT
SIZE
ET
ET
R
WF
WF
FF
FF
XS
EX
EO
EO EX G
WF K
J EO EL
SE + STROKE
EE
P + STROKE
XE+ STROKE
SIDE LUG MOUNT
STYLE SL (MS2)*
CENTER LINE LUG MOUNT
STYLE CL (MS3)*
END LUG MOUNT
STYLE EL (MS7)*
DRAWING A DRAWING B
*ANSI/B93.1-1964 Mounting Style
Designation.
IMPORTANT NOTICE
SL and CL MOUNTS – The round
gland retainer shown above is not used
on the 1
1 / 8 " bore, 1 1 / 2 " bore, or the
2 1 / 2 " bore with a 1 3 / 4 " rod diameter
and the 3 1 / 4 " bore with a 2" rod
diameter.
A square retainer, the same square size
as the head is employed on these sizes.
The retainer is held in place with
retainer screws that thread into the
head. The rod gland can be removed
without loosening the tie rods in all
sizes. See adjacent Drawing A.
EL MOUNT – The round gland
retainer shown above is not used on
the 1
1 / 8 " bore, 1 1 / 2 " bore, 2" bore, the
2 1 / 2 " bore with 1 3 / 8 " and 1 3 / 4 " rod
diameters, and the 3 1 / 4 " bore with a 2"
rod diameter. A square retainer, the
same square size as the head, is
employed on these sizes. The lugs
serve as nuts on the bottom two tie
rods, and the top two tie rods use tie
rod nuts. The rod gland cannot be
removed without loosening the tie
rods in these sizes. See adjacent
Drawing B.
MM
ROD
DIA.
E-.003
2-.008
Available 1 1 / 8 " thru 8" Bore only
1 HH-11