MyWeigh 3001P - Manual (Page 5)

3) Place a 2kg (3001P) or 5kg (7001DX) weight on the tray, wait 3 seconds then press TARE. Calibration is
complete.
NOTE: If after calibration your scale does not read accurately, this indicates calibration error and the
calibration process should be repeated more slowly.
Please calibrate on a very stable flat surface!
INACCURACY/ERROR
The primary reasons for inaccuracy or malfunction are low batteries, incorrect calibration, overload or
operating on an unstable surface. Please keep this in mind and maintain and operate your scale
properly. The scale is a precise instrument and must be handled with the utmost care and caution.
FEATURE
Ø Power Up Segment Test
When first turning the unit on, all segments of the display will appear from “99999” to “00000”.
Ø Overload
When an applied load exceeds the maximum capacity. It will display “- - - - -“, Remove the excessive load
immediately!
Remember: You can permanently damage the scale by overloading it!
Ø Negative Value
Any tared value or a value left in memory will be displayed as a negative number once all weight is
removed from the tray. Press TARE to re-Zero the unit