MyWeigh 3001P - Manual (Page 3)

§ Handle with care. Gently apply all items to be weighed onto tray top. Although this scale is designed to
be quite durable, avoid rough treatment as this may permanently damage the internal sensor and void
your warranty.
§ Avoid lengthy exposure to extreme heat or cold, your scale works best when operated and stored at
normal room temperature.
§ Place the item to be weighed on the platform, after the stable weight is displayed remove the item
immediately. This will prolong the longevity and accuracy of this weighing instrument.
Turn on The Scale
Press to turn on the scale. The scale will go through a quick warm up procedure and self test, and then it
will show “0” on the display and be ready for use.
Display Widow
HOLD: Current weight reading is held. : Current reading is stable.
: Scale is in Zero mode. : Scale is in TARE mode.
: Battery is at low voltage or under heavy load.
KEY PAD FUNCTIONS
u UNIT
UNIT(mode) selection: Press and release the key once to change weight unit. You can select g (grams),
kg (kilograms), lb (pounds) or lb/oz (ounces).
§ Power switch
Press this key to turn unit on. Once the unit is on, press and hold the same key to turn the scale off.
§ HOLD
Press this key to hold current weight reading, press again to cancel.
§ TARE : Zero or tare
Press TARE to reset the scale to zero when the weight on the tray is below 5% of the Maximum Capacity
of the scale. This key is also used as a TARE function when the weight on the tray is above 5% (eg above
150g for the 3001) The tare indicator will appear and the display will show “0”.
§ (My Weigh Logo Key) Backlight switch. Press to turn the backlight on or off.
Buzzer / Beep Function