MyWeigh 3001P - Manual (Page 4)

To enable (or disable) the Beep function, turn the scale on, then press and hold HOLD at least for 8
seconds. The beep’s state (on/off) is changed when the “HOLD” mark on the display has disappeared.
AC ADAPTOR
The scale can be operated on AC power with a standard AC adaptor which output is DC 4.5-6volt
NOTE: Please only use the correct AC adaptor for this scale – an incorrect AC adaptor can cause damage
to the scale and possible fire or injury.
OPERATION
Battery Operation:
1) Three “AA” size ALKALINE batteries (1.5V*3) are required.
2) To install batteries:
a) Release the battery cover by sliding out-wards.
b) Place batteries into battery compartment aligned correctly.
c) Replace battery cover.
3) The scale is now ready for battery operation.
AUTO TURN OFF&AUTO BACKLIGHT&BUZZER CONTROL
Begin with the power OFF. Press and hold the MW center button and ON/OFF to turn on the scale, the
display will show “00000”, then it will show “OFF 0”(disabled) or “OFF 1”(automatic turn off after about
2 minutes) or “OFF 2”(automatic turn off after about 5 minutes), select the auto turn off time by press
UNIT. Now confirm your selection by pressing TARE. Now the display will show “BL 0”(backlight turn off
is disabled) or “BL 1”(auto backlight will turn off after about 1 minute) or ” BL 2” (auto backlight-off after
about 2 minutes), select auto backlight time by pressing UNIT , confirm it by pressing TARE . Now the
display will show “bb 0”(Beeper is disabled) or “bb 1”(Beeper is enabled), choose your selection by
pressing UNIT, confirm it by pressing TARE. The scale will return to active weighing.
(Advanced users only) CALIBRATION
IMPORTANT: This scale was professionally factory calibrated before shipment. It does NOT need to be
recalibrated before use and will not usually require calibration during its lifetime. However some
advanced users who seek optimum accuracy may wish to calibrate the scale periodically to maintain
perfect accuracy. Incorrect calibration can occur if you do not follow the steps exactly. You will need a
2kg weight (3001P) or 5kg (7001DX) weight to calibrate this scale.
1) Turn the scale OFF and place it on a FLAT, very stable surface .
2) Press and hold UNIT and to turn on the scale, wait for the display to show “CALE”.