MyWeigh 1SCALE - Manual (Page 2)

Note : If the battery symbol appears in the display during normal operation, it means low battery power.
It is time to replace the battery. If the power is too low, it will show “Lo” when power on and then turn
off automatically.
Weighing Function
1. Turn the scale on by pressing the key below the LCD.
2. Once display shows “0”, place the item to be weighed onto the scale platform and the weight will
appear in the display.
3. There is a stability indicator “H” in the top left corner of the screen. Whenever the “H” is displayed,
that means that displayed weight is stable.
Note : The scale will read ERR if it is trying to weigh above it’s capacity.
To turn off the scale
Press and hold the key for 3 seconds to turn off the scale after use.
To use TARE Function
1. After weight is displayed, press and quickly release the key once. The Display will return to “0”.
2. Add next ingredient. Weight of the new ingredient will show in display. Repeat these two steps until
all ingredients are added.
3. Remove all ingredients to get the total weight.
To set oz or gram
The selection of grams or ounces is done at startup. Make sure the scale is turned off first. Then turn on
the scale but hold down the key (the button) for a few extra seconds. The “oz” and “g” icons will toggle
repeatedly. Release the key when the desired unit is showing on the display (either G or OZ). The
selected unit will be saved and the scale will remain in that mode until you change it again.
Auto Power Down
The scale turns off automatically after idle / non-use of about 90 seconds.
Precautions
1. Do not clean the unit with abrasive or corrosive compound. It may scratch the plastic and corrode the
electronic circuit. (NOTE: Do not use Alcohol or any Alcohol based solution to clean the scale)
2. Do not overload the scale. Not to place anything that weighs more than 2000g on the platform, or it
may permanently damage the weighing sensor.