MyWeigh AXE300 - Manual (Page 3)

replacing your batteries before you calibrate. You will need a 100gram weight to calibrate this scale.
NOTE: if you do not have access to a 100g weight you can purchase one at your local store or in
emergency situations you can use 100g of coins or weights (ie 20 US Nickels = 100g) as a 100g weight..
1) Turn the scale OFF and Place the it on a Flat, very stable surface
(Be certain the scale is OFF)
2) Press and hold the key for 10 seconds until a random large
number appears on the display - then release the key.
3) Press the key again, the display will show 2Ero and then
100.0
4) Gently place a 100 gram weight on the scale and wait 3 seconds.
5) Press the key. The display will show CAL and then PASS,
calibration is complete. Remove the weight, then Press and hold the key for 5 seconds to turn the
scale off.
NOTE: if after calibration your scale does not read accurately, this indicates calibration error and the
calibration process should be repeated more slowly.
Please calibrate on a very stable flat surface
INACCURACY / ERROR___________________________________
The primary reasons for inaccuracy or malfunction are low batteries, incorrect calibration, overload or
operating on an unstable surface. Please keep this in mind and maintain and operate your scale
properly. The scale is a precise instrument and must be handled with the utmost care and caution.
FEATURE_______________________________________________
* Power Up Segment Test
When first turning the unit on, all segments of the display will appear as shown below. This display will
remain for approximately 2 seconds and then reset to 0.
1:8:8:8:8
* Overload