MyWeigh AXE300 - Manual (Page 2)

* Allow sufficient warm up time. Turn the scale On and wait several seconds to give the internal
components a chance to stabilize before weighing.
* The cleaner the environment the better. Dust, dirt, moisture, vibration, air currents and proximity to
other electronic equipment can all cause an adverse effect on the reliability and accuracy of your scale.
* Handle with care. Gently apply all items to be weighed onto tray top. Although this scale is designed to
be quite durable, try to avoid rough treatment as this may permanently damage the internal sensor and
void your warranty.
* Avoid shaking, dropping or otherwise shocking the scale. This is a precision instrument and MUST BE
HANDLED WITH EXTREME CARE.
* Only operate the scale on a stable, vibration free surface. IMPORTANT: Do not operate near cell
phones, radios, computers, or any other electronic device.
.** These electronic scale are precision instruments. Do not operate near an in-use cell phone, cordless
phone, radio, computer or other electronic device. These devices emit RF and can cause unstable scale
readings. If your scale ever performs poorly, try moving the scale to a different room or location. This is
a very precise scale - the display may seem to wander or jump when weighing. This is due to air currents
or vibrations. Stable weighing is achieved when the display remains fixed for 3 seconds.
OPERATION_____________________________________________
Battery Replacement:
1) Three #357 button batteries are required.
2) To install batteries:
a) Release the battery cover by sliding out-wards.
b) Place batteries into battery compartment aligned correctly.
c) Replace battery cover.
DO NOT USE EXCESSIVE FORCE & DO NOT PRESS ON THE TRAY!!!
3) The scale is now ready for battery operation.
(Advanced users only) CALIBRATION______________________
IMPORTANT: This scale was professionally factory calibrated before shipment and does NOT need to be
recalibrated by the end user. However, if you wish to recalibrate your scale we provide these
instructions for calibration: Repeat calibration if the scale ever shows Out2. Incorrect calibration can
occur if you do not follow the steps exactly. If your scale does not perform accurately, please try