MSI 945GC Networks - Manual (Page 34)

2-18
M S-96C4 Server Board
CompactFlash Card Slot: CF1 (Optional)
This CompactFlash slot shares one channel of the IDE controller (CF => Master; IDE
=> Slave). You can install one CompactFlash typeI / type II device.
Important
* The CF1 slot and the IDE1 connector shares and uses the same channel. CF1
and IDE1 can support up to 2 IDE devices without CF device or 1 IDE device
with 1 CF device.
* If you install two IDE devices, you must configure the second drive to Slave
mode by setting its jumper. Refer to the hard disk documentation supplied by
hard disk vendors for jumper setting instructions.
* If you install one IDE device with ATA100 IDE cable and one CF device, you
must configure the CF device to Master mode by setting jumper J6. CF only
supports Master mode by using ATA100 IDE cable. CF only supports Slave
mode by using ATA33 IDE cable.
CF Mode Jumper: J6
This jumper is used to select Master/Slave mode of the CF device.
CF Voltage Jumper: J4
This jumper is used to select the operating voltage of the CF device.
CF1
Master Slave
J6
1
1
3
1
3
VCC3 VCC5
J4
1
1
3
1
3
PDF created with pdfFactory Pro trial version www.pdffactory.com