Configure/view scsi settings, Scsi bus interface definitions – MSI MS-9638 series User Manual
Page 75
C-4
MS-9638 Server Board
Configure/View SCSI Settings
SCSI Bus Interface Definitions
SCSI Controller ID
The item is used to assign a SCSI ID to the SCSI controller. It is recommended that you
should leave the default setting unchanged. Settings: [0] ~ [15].
SCSI Controller Parity
Use the field to enable or disable SCSI parity error checking function. If any of your
SCSI devices does not support parity checking, disable this function. W hile disabling
the function, you should disable disconnections for all devices, as parity checking for
the reselection phase is NOT disabled. A non-parity device
’s I/O operation will never
complete if the reselection fails due to a parity error.
SCSI Controller Termination
In order to have the SCSI bus function properly and reliably, termination at the ends of
the SCSI bus is necessary. Proper termination can ensure signal on the SCSI bus will
not reflect and cause data loss or errors. Settings options: [Enabled], [Disabled].
There are 8 items in the
“Configure/View SCSI Controller Settings” screen. These
items display or allow you to change the SCSI controller
’s settings. Use the arrow
keys to highlight the item and then press
item or enter each item
’s sub-menu screen.
AIC-7901 at slot 00, 05:05:00
SCSI Bus Interface Definitions
SCSI Controller ID .................................... 7
SCSI Controller Parity ............................. Enabled
SCSI Controller Termination .................. Enabled
Additional Options
Boot Device Configuration ..................... Press
SCSI Device Configuration ...................... Press
Advanced Configuration .......................... Press
HostRAID ................................................... Enabled
Configuration
Interrupt (IRQ) Channel .......................... 1 1
I/O Port Address ........................................ B000h, B400h
BIOS Information
9638v1.0-Appendix C(SCSI BIOS).p65
2006/11/9, 下午 03:33
4