iRobot Looj - Manual (Page 8)

1 iRobot Looj Owner’s Manual www.irobot.com 1
Using iRobot
®
Looj
™
always test Looj before using it.
Prior to using Looj, try driving forward and backwards. Try spinning the auger
in both directions. Note the lights on the remote control handle and on the
robot blink during transmission.
Also, practice attaching and detaching the handle as described on page 12.
using Looj
1. Attach Looj to the belt clip or place Looj into holster.
2. The optimum spot for ladder placement is away from wires,
hazards, on flat ground, etc. Read and follow ladder instructions
provided by the ladder manufacturer before using a ladder.
See “Important Safety Instructions” section for more details.
3. Climb the ladder.
4. Place Looj into the gutter and clear debris
with the robot so that Looj rests on bottom
of gutter. Clear all debris in front of the ladder
before starting auger to avoid being sprayed
in the face.
5. Switch the power switch on the robot to turn it on. The power light
should be green to indicate that its battery is charged. A red
power light indicates that you should charge Looj’s battery.
6. Detach the remote control handle.
attaching the Looj belt Clip
The Looj belt clip is designed to hold Looj while you climb up and down the
ladder. Always use the belt clip or the optional holster accessory (see below)
when using Looj on a ladder.
To use the belt clip, remove your belt and thread it through the belt slots.
The robot hook should be on the bottom of the clip when attached to your
belt. Attach the robot to the robot clip.
Caution: always keep the belt clip on the side of your body. Placing the
robot in the front may cause it to be kicked by your leg and fall off.
Caution: never use Looj on a ladder without the belt clip or the holster to
hold the robot while you climb or descend.
Looj Holster accessory (optional, not included in all models)
Use the Looj Holster Accessory as a storage device and to keep your clothing
clean while carrying Looj. The holster includes a belt and a pouch to hold the
fully assembled Looj and remote control handle. There is also a loop on the
back for hanging.
• Fold antenna underneath antenna hook on
the remote control handle before placing
in the holster.
• Place Looj in the holster with the auger facing up.
Belt Slots
Robot Hook
belt Clip
Caution: Wear safety glasses when
using Looj to protect your eyes from debris.