iRobot Scooba 390 Series - Manual (Page 11)

20 iRobot Scooba Owner’s Manual
en
www.irobot.com 21
en
remember to re-install Filter
Be sure to re-install the filter after you remove and rinse it. Make sure it is
properly seated; never force the filter into place.
re-install the Vacuum Port
Always re-install the vacuum port, and ensure that it is properly seated.
Do not force the vacuum port into place.
Troubleshooting
warning lights
Scooba has several warning lights that tell you if the robot needs assistance.
warning light Possible Cause what To Do
Check Brush
Light
The brush is jammed Remove and clean Scooba’s brush and cleaning
head. With cleaning head and tanks removed,
turn Scooba over, inspect and clean the cleaning
head area.
The cleaning head is
improperly installed
Remove and replace Scooba’s cleaning head.
(page 18)
The filter is missing Remove, rinse and replace Scooba’s filter. Ensure
filter is installed properly. (page 17)
Check Tank
Light
The tank not is in
the robot
Place the tank in the Robot and make sure the
tank latch is securely closed.
The cleaning cycle
is compete
Empty the Dirty and Clean tanks.
(see page 23 for additional troubleshooting)
The pump needs to
be primed
Prime Scooba’s pump with the included
suction bulb. (see page 24 for details)
Power Light
(Red)
Battery is discharged Recharge Scooba’s battery. (page 11)
X Incorrect
X Incorrect
Service
Light
Power
Light
Clean
Light
Check Tank
Light
Check Brush
Light
I’m Stuck
Light
a Correct
a Correct