iRobot Scooba 390 Series - Manual (Page 10)

18 iRobot Scooba Owner’s Manual
en
www.irobot.com 19
en
Clean scooba’s Brush after every use
Scooba’s brush is located inside a cartridge called the “cleaning head”.
Access to the cleaning head is inside Scooba, so the tank needs to be open
when removing and replacing the cleaning head.
rinse scooba’s Vacuum Port after every use
1
Push the Brush Eject button to remove
the cleaning head.
2
Open the cleaning head and remove
the brush.
3 Rinse cleaning head and brush under
warm water.
4
Replace Scooba’s cleaning head.
1
Remove vacuum port.
2 Rinse under warm
water.
3 Replace vacuum port.
Avoiding Common Mistakes
Your iRobot Scooba will not clean effectively if the battery, cleaning head,
filter or vacuum port are not properly installed. Here are a few common
mistakes you can easily avoid to ensure best results.
Make sure Battery is Installed Correctly
When the battery is properly installed, the yellow battery tabs should fit into
their guide holes.
Click Cleaning Head into Place
When the cleaning head is properly installed, you should hear it click into
place. For best results, push down on the robot base while installing the
cleaning head.
Do Not
Force
X Incorrect a Correct
X Incorrect a Correct