iRobot Verro 300 - Manual (Page 29)

iRobot
®
Verro
™
model 300
QUICK START GUIDE
An easy step-by-step guide to using the
iRobot Verro Pool Cleaning robot
iRobot
®
Ver ro
™
model 300 Quick Start Guide
© 2007 iRobot Corporation, 63 South Avenue, Burlington, MA 01803. All rights reserved. iRobot is a registered trademar k and Ver ro is a trademark
of iRobot Corporation. Cover photo © Veer incor porated 2002 - 2005. All rights reserved.
3002.07
Quick Start
(cont...)
See Owner’s Manual
for detailed product
instructions.
Visit
www.irobot.com/usetips
for instructional photos
8 After approximately two hour s, V erro will stop and the P ower Supply light will
turn off. T o stop Ver ro before the end of the cleaning cycle, switch the P ower
Supply OFF .
9
W
ait 20 minutes before removing V erro from the pool to allow the pump motor
to cool. Shut off and unplug the Pow er Supply ever y time you remove the
cleaner from the water . Always remember to tur n the Pow er Supply OFF and
unplug it from the power outlet before remo ving the cleaner from the pool.
10
Unplug the P
ower Supply from the GFCI outlet. Ne ver leave the P ower Supply
plugged in when Ver ro is not in use.
11 Unplug the fl oating pow er cord from the Pow er Supply.
12
Use the fl
oating pow er cord to pull Ver ro to the edge of the pool, then use the
handle to lift it out of the water . Water will drain from V erro as it is lifted.
CAUTION: Removing V erro b y its fl oating pow er cord may cause se vere damage
to the cord requiring costly repairs.
13
Store V
erro and its P ower Supply in a dr y area out of direct sunlight. The Pow er
Supply is water resistant, but not water proof, and ma y be damaged by rain.