EasyN F2 Series Central Management System User Manual
Page 9
8
MV-F2E-E-1.0.6.45
Down
The camera tilted downward
Left
The camera shake to the left
Right
The camera shake to the right
+
To make the camera zoom is far
-
To make the camera zoom close
Near
Near the camera focus
Far
Far from the camera to focus on
Stop
Stop PZT control
Notice: Hold down the mouse over the operation, the operation should be carried
out relative,when the release of the mouse,the operation will be stopped relative.
4. Preset
Set：
Set the current PZT positon as the preparative position
Clear：
Clear current PTZ preparative position
Go： Start
cruise
Start：
Start Point of cruise
End：
End Point of cruise
Auto：
Open or close the function of auto cruise
5. GPIO Control
Button control GPIO GPIO port level, green low, red high, brown says
unknown
The button corresponding GPIO port settings, see the menu [System ->
Options -> GPIO Config]
6. Audio & Video Control
Resolution： Adjust the revolution of the camera
Brightness： Adjust the brightness of the camera
Contrast：
Adjust the contrast of the camera
Saturation： Adjust the saturation of the camera
Hue：
Adjust the hue of the camera (
MJ do not have the property
)
Volume：
Adjust the volume of the camera
Camera Mode：Adjust the motion jpeg ipcam’s camera mode.[in door/out
door](
unused now
)