Kramer Electronics TP-45EDID - Manual (Page 16)

TP-45EDID - Connecting a Component/XGA – Audio Distribution System 13
Figure 3: Component/XGA – Audio Distribution System, Component Video Mode
5.3 Connecting the TP-45EDID Remote Control
Connect momentary push-buttons and LEDs (each LED is driven by a 5V source
and a 392Ω series resistor) to a cable and attach the cable to a 5-pin terminal
block for connection to the TP-45EDID control port as shown in Figure 4 .
Each press of the selector button toggles the audio or video system mode and
turns on or off the remote and panel status LEDs according to the active mode.