Kramer Electronics TP-45EDID - Manual (Page 13)

10 TP-45EDID - Connecting a Component/XGA – Audio Distribution System
5.1 Connecting the System in XGA Mode
To configure a TP-45EDID and TP-46N Component/XGA – Audio distribution
system (using up to 300ft (100m) of UTP cabling) in the XGA mode, as illustrated
in the example in Figure 2 , do the following:
1. On the TP-45EDID, connect the following:
 An XGA source (for example, the graphics card on a laptop) to the
XGA 15-pin HD (F) connector
 An analog audio source to the ANALOG AUDIO 3.5mm mini jack (or a
digital audio source to the S/PDIF RCA connector), for example, using
a Kramer C-GMA/GMA cable (VGA 15-pin HD (M) with audio jack to
VGA 15-pin HD (M) with audio jack
2. On the TP-45EDID, use the SELECT buttons as follows:
 Momentarily press the video SELECT button. The UXGA LED lights
when the UXGA input is selected
 Momentarily press the AUDIO SELECT button to toggle between the
S/PDIF and analog audio inputs
3. On the TP-46N, connect the following:
 The XGA OUT 15-pin HD (F) connector to the XGA acceptor (for
example, a display)
 The ANALOG AUDIO 3.5mm mini jack to the analog audio acceptor
(for example, powered speakers)
4. Connect the LINE OUTPUT RJ-45 connector on the TP-45EDID to the LINE IN
RJ-45 connector on the TP-46N, via CAT 5 cabling, see Figure 5 .
5. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on both the TP-45EDID and the TP-46N (not
shown).
The signal from the XGA source is transmitted via CAT 5 cable, decoded
and converted at the XGA OUT 15-pin HD (F) connector to the XGA
acceptor.
6. If required, connect the LINE OUT RJ-45 connector on the TP-46N to an
additional TP-46N.