Kramer Electronics TP-43 - Manual (Page 13)

Connecting the TP-43 Component – S/PDIF Transceiver
9
5. On the TP-42, connect the:
Y, U, and V RCA (component video) OUTPUT connectors to
a component acceptor (for example, a plasma display), and
the S/PDIF (digital audio) RCA OUTPUT connector to an
AV Receiver
6. On each unit, connect a 12V DC power adapter to the power socket and
connect the adapter to the mains electricity (not shown in Figure 6).
7. If necessary, adjust 1 the appropriate level(s) on the TP-41 2 , the TP-42 3 and
on each of the three TP-43 units 4 .
1 Insert a screwdriver into the small hole and carefully rotate it, trimming the level
2 That is, the audio level and the Y, U, and V levels
3 That is, the audio level, the audio EQ., the Y, U, and V levels, and the Y, U, and V EQ.
4 That is, the local output: Y, U and V signal levels / compensation equalization levels, and the digital audio S/PDIF level and
compensation equalization level, as well as the line output: Y, U and V signal levels, and the digital audio S/PDIF level