Kramer Electronics TP-43 - Manual (Page 10)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the TP-43 Component – S/PDIF Transceiver
6
5.1 Connecting a TP-43 Component – S/PDIF Transceiver
To configure a TP-43 Component – S/PDIF Transceiver, as the example in
Figure 5 illustrates, do the following:
1. Connect the:
Y, U, and V RCA (component video) OUTPUT connectors to
a component acceptor (for example, a plasma display)
S/PDIF (digital audio) RCA OUTPUT connector to an AV
Receiver
2. Connect the LINE IN connector of the TP-43 to the LINE OUT connector
of the TP-41, via UTP cabling (maximum range of 300ft (100m)).
3. Connect the LINE OUT connector of the TP-43 to the LINE IN connector
of the TP-42, via UTP cabling (maximum range of 300ft (100m)).
4. Connect a 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in Figure 5).
5. If necessary, adjust 1 the appropriate level(s) of the TP-43, the:
Local output: Y, U and V signal levels, Y, U and V
compensation equalization levels, and the digital audio
S/PDIF level and compensation equalization level
Line output: Y, U and V signal levels, and the digital audio
S/PDIF level
1 Insert a screwdriver into the small hole and carefully rotate it, trimming the level