Kramer Electronics FC-7402 - Manual (Page 5)

Using Your FC-7402 SDI to Analog Converter
3
Table 1: Front Panel FC-7402 SDI to Analog Converter
# Feature Function
1 POWER Switch Illuminated switch supplying power to the unit
2 HUE Button Press the HUE button and adjust using the + and – buttons
3 CONT (CONTRAST) Button Press the CONT button and adjust using the + and – buttons
4 BRIGHT (BRIGHTNESS) Button Press the BRIGHT button and adjust using the + and – buttons
5 SHARP Button Press the SHARP button and adjust using the + and – buttons
6 COLOR Button Cycles between SATURATION, R-Y, and B-Y. The corresponding
LED lights
7 SATURATION LED Lights after selecting SATURATION via the COLOR button
8 R-Y LED Lights after selecting R-Y via the COLOR button
9 B-Y LED Lights after selecting B-Y via the COLOR button
10 STO Button Stores the current setup in the non-volatile memory
11 RCL Button Recalls a setup from the non-volatile memory
12 - Button Press to decrease
13 + Button Press to increase
14 7-segment Display Displays data when using a front panel button; briefly displays
firmware version when machine is turned on
15 PANEL LOCK LED Illuminates when the panel is locked (blinks after pressing a button
when the panel is locked)
16 PANEL LOCK Button Engages/disengages the front panel buttons
Table 2: Rear Panel FC-7402 SDI to Analog Converter
# Feature Function
1 SDI IN BNC Connector Connects to the SDI source
2 SDI OUT BNC Connector Connects to the reclocked and equalized SDI acceptor
3 Y / G OUTPUTS BNC Connector
4 B-Y / B OUTPUTS BNC Connector
5 R-Y / R OUTPUTS BNC Connector
Connects to the RGB
1
or component
2
video acceptor
6 YC OUTPUT 4p Connector Connects to the s-Video (Y/C) output
7 CV OUTPUTS BNC Connector Connects to the composite video output
8 Dipswitches Dipswitches setup (see section 5.1.2)
9 RS-232 Port Connects to the PC or the Remote Controller
10 Power Connector with Fuse AC connector enabling power supply to the unit
5 Using Your FC-7402 SDI to Analog Converter
You can use your FC-7402, to convert SDI video to professional quality
analog video—composite video, s-Video and component
3
(YUV or RGB)
video—as the example in Figure 2 illustrates.
1 For RGB video, connect all 3 connectors: G, B, and R
2 For component video, connect all 3 connectors: Y, B-Y, and R-Y
3 Y, B-Y, R-Y is also known as Y, Pb/Cb, Pr/Cr, or YUV or Y, Pb, Pr