Kramer Electronics FC-7402 - Manual (Page 2)

Contents
i
Contents
1 Introduction 1
2 Getting Started 1
3 Overview 1
4 Your FC-7402 SDI to Analog Converter 2
5 Using Your FC-7402 SDI to Analog Converter 3
5.1 Connecting the FC-7402 SDI to Analog Converter 4
5.1.1 Connecting a PC 5
5.1.2 Dipswitch Settings 6
5.1.3 Adjusting Oversampling to x2 (Moving Jumper JMP1) 7
5.2 Operating the FC-7402 SDI to Analog Converter 8
5.2.1 Storing/Recalling Setups 8
5.2.2 Locking the Front Panel 9
6 Technical Specifications 9
7 Communication Protocol 10
Figures
Figure 1: FC-7402 SDI to Analog Converter 2
Figure 2: Connecting an FC-7402 SDI to Analog Converter 4
Figure 3: Connecting a PC without using a Null-modem Adapter 5
Figure 4: Adjusting Oversampling to x2 (Moving Jumper JMP1) 7
Tables
Table 1: Front Panel FC-7402 SDI to Analog Converter 3
Table 2: Rear Panel FC-7402 SDI to Analog Converter 3
Table 3: Dipswitch Definitions 6
Table 4: Dipswitch Settings (AUTO, PAL, and NTSC) 6
Table 5: Technical Specifications of the FC-7402 SDI to Analog Converter 9
Table 6: Structure of the Protocol 10
Table 7: Instruction Set for the FC-7402 10