Kramer Electronics SPK-W511(PAIR) - Manual (Page 8)

SPK-W511 - Installing the SPK-W511 5
6. Insert the brackets (see Section 4.3 )
4.3 Installing the Mounting Bracket
To install the mounting brackets, do the following:
1. Mark the location of the mounting holes on the wall.
2. Screw the mounting screws onto the wall at the location where you want to
mount the speakers.
If the location is backed by wall studs, you can use the wood screws
provided. If the location is backed by a gypsum board, use wall anchors (not
included in the package).
3. Slide a speaker into each mounting bracket.
4. Align the bracket screw holes (upper and lower) to those on the speaker and
screw a knob to each of the holes to secure the speaker to the bracket (see
Figure 2 ).
Figure 2: SPK-W511 with Brackets Connected
5. You can slightly loosen the knobs on a speaker to adjust its direction.