3 web access, Web access, Figure 11: web access login – Kramer Electronics WP-501 User Manual
Page 12: On 3)

Web Access
9
3 Web Access
Web Access
lets you monitor and control the room and is automatically
generated by Kramer K-Config.
You can login to
Web Access
either via the
Site-CTRL
Room List tab (see
Section 2.2
) or via your Internet browser.
To enter
Web Access
via your Internet browser, make sure that your PC is
connected via a network to the Room Controller, and do the following:
1. Open your Internet browser.
2. Enter the unit’s IP number
in the Address bar of your browser.
Figure 10: Entering the IP Number in the Address Bar
3. You will be prompted to enter your user name (User or Admin) and
password
to login:
Figure 11: Web Access Login
The administrator can control the room via
Web Access
, performing tasks
such as scheduling, switching inputs, setting the audio and so on. The tasks
available for the user are limited.
summarizes the tasks performed by
the User and the Administrator:
Table 5: User and Administrator Available Operations using Web Access
Tasks
User
Administrator
Master Room
Controller
Click inputs/configurable
buttons, audio adjustment
Select buttons, audio adjustment, advanced audio
settings
Auxiliary Controller
Click configurable buttons
Click configurable buttons
Device Serial
commands
Click serial command
Click serial command
Macros
Activate
Activate
Scheduled Tasks
No access
Write, delete and edit tasks
Settings
View only
Change: Name (Master and Auxiliary devices), IP
Address, DHCP, Gateway, Subnet Mask, Date, Time
1 The default IP number is 192.168.1.39, and may be changed by the system integrator
2 The factory default password is admin. The password can be changed via Kramer K-Config